Jump to content
The Corroboree
Sign in to follow this  
Freakosystem

Air Still

Recommended Posts

Does anybody here have experience using an air still to distill alcohol for plant extracts, tinctures or essential oils? I understand the limitations of these kits are that they're only capable of distilling small amounts which aren't considered particularly practical for producing spirits for consumption but the smaller amounts needed for tinctures seem to make this a worthwhile thing, particularly given how difficult it is to otherwise obtain high proof without methanol contaminants.

 

Anybody ventured down this road?

Share this post


Link to post
Share on other sites

Off-topic but maybe still relevant, the manufacturer of "bubble bags" claims they can be used to extract essences from almost any plant material, using nothing but ice-water, agitation and serial filtration. 

Share this post


Link to post
Share on other sites

Technically, you'd need a licence (in Australia, but not New Zealand) to produce even the limited quantities of pure alcohol you require?

 

Share this post


Link to post
Share on other sites

From what i hear air stills produce quite low quality alcohol. I have a Turbo 500 reflux and I get around 94% of smooth spirit.  Very easy to use.

  • Like 1

Share this post


Link to post
Share on other sites

I do have experience with the air still. The air still will produce an end result of around 60% ABV. Traditionally you collect the first 700-800ml after which the quality of the product drops off very quickly. You then water it down to 1 - 1.25 litre at 40% abv.

They are designed to not produce methanol at the start so seperating heads, body and tails is not necessary with the air still. Although for your purposes the "heads" of the process will be a much higher percentage ABV... Probably in the 90s. I couldn't tell you the volume you would get at that ABV though, my guess would be maybe 100ml, but that really is just a guess and would have to be experimented with.

The way a still works for alcohol is based on the fact that alcohol boils and evaporates at a lower temperature than water. 80°c for ethanol and 100°c for water. So as the still heats up the ethanol evaporates and comes out first (along with some methanol, but not in the air still). 

The other thing is, based on preference but very much suggested, is that the alcohol then needs to be filtered through charcoal. The air still comes with a kit to do this but the kit only works for alcohol at 40% or below. 

The answer in the end is that the air still can be used for your purposes but it isn't the ideal product for it. I get that it is half the price of a bigger, better still but if very high ABV alcohol for tinctures is all you want you should probably get a real still.

      The air still is basically the "distilling for dummies" tool, which isn't to knock it because it is actually a good product. But it's really only made for one thing and that is to make a 40% ABV neutral spirit. Getting anything else out of it will be going against the recommendations of what it is for and is up to you. 

If you do decide it is what you want to use then here are the tips I will give you.

Use turbo yeast packets, they are the best for your purposes and also contain nutrients for the yeast. 

Use 100% dextrose if you can. It produces a much smoother end result than other sugars and is 100% fermentable meaning if all goes right it will be totally gone at the end of fermentation and no lingering bits will hang around effecting the taste. Other sugars don't completely disappear like dextrose does. Although if you want to save money and don't care as much about any of that, then just bags of sugar from Coles work too.

Add liquid charcoal to your fermenter. It will keep the fermentation process from getting contaminated and is easy enough to remove at the end of the process when you add your clearing agents.

Degas the brew thoroughly before distilling. Think of how fizzy a bottle of coke is, that is about as carbonated as your brew is going to be. The goal is basically to make that bottle of coke go flat. People stir the crap out of it for as long as they can to get all the bubbles out, this process is a pain in the ass. I prefer to put a second fermenter under the other one and turn the tap so it all comes pouring out from one into the other. As the brew lands in the second container it will de-gas little by little. Just repeat the process over and over. It will take just as long but is easier than stirring with a stick.

You can get away with not completely getting every last bubble out when it comes to the air still. But it is dangerous to try and distil carbonated brew in any still. There are little ceramic things you throw in the bottom of the still which help break up any bubbles and "distilling conditioner" that will do the same. These are what make it not so bad to half ass the degassing a touch. I still wouldn't recommend it though, bubbles can lead to booms.

You will read the instructions to the still anyway so I am not going to go through every step. Just remember when you turn it off at the end DO NOT open it straight up. Leave it for a full day to cool down and it really will take that long. This slows down the process a fair bit since it takes 4 litres at a time so you have to 5-6 runs for one 23 litre fermenter worth (other stills will do the whole thing in one run). But don't risk opening it up early, severe burns can happen.

Apart from that, the thing is pretty safe to use compared to other stills. It has an automatic killswitch that prevents it from running while dry. And the top of it provides enough of a seal to do the job, but not enough to create a bomb. Plus there is no flames needed which can be dodgy around alcohol vapours.

But yeah dude, that is all I can think to add on the air still, ask if you want to know anything specific.

  • Like 2

Share this post


Link to post
Share on other sites
On 7/11/2021 at 12:57 PM, fyzygy said:

Technically, you'd need a licence (in Australia, but not New Zealand) to produce even the limited quantities of pure alcohol you require?

 

 

Home distillation is ILLEGAL in OZ - However, the law is grey because the criminal law does not cover distillation it is under the excise act. As long as you do not trade or sell products the ATO and the police do not seem to care. Do not talk about it do not promote it not even to friends or family. Distillation is HUGE in Australia. This is why homebrew shops can sell stills and boilers and the police do not care. Walk into any homebrew shop and see the shelves and shelves of flavours that you can add to neutral spirits. No one is adding this stuff to commercial vodka. Then you will see the 25kg bags of dextrose sugar. Mountains of the stuff. They are used to make sugar wash turning it into neutral spirits. Not sweetening coffee.

 

However, I fear a change in community attitudes and government could force a crackdown. Police raiding people's homes, smashing down your grandfather's door.

 

Australian drug law is broken. Australia has become a boring conservative dystopian nation of bureaucrats.

 

Remember the Australian Larrikin. They no longer exist. They were deemed "inappropriate" lacking "data".

 

I am not against science and reason I am vaccinated and covid is not fake news. Just drug laws that are anti-scientific and a war that has failed.

 

On 7/11/2021 at 3:20 PM, mr b.caapi said:

From what i hear air stills produce quite low quality alcohol. I have a Turbo 500 reflux and I get around 94% of smooth spirit.  Very easy to use.

 

It is not as good as full proper still but it works - See https://www.youtube.com/c/StillIt/videos for some great examples of what you can do.

 

Here are two videos

 

 

 

 

 

On 16/5/2022 at 9:01 AM, Ricardo said:

They are designed to not produce methanol at the start so seperating heads, body and tails is not necessary with the air still.

 

Sorry, this is incorrect distillation cuts aka heads/hearts/tails is physics no technology or product can get around the fact that acetone, methanol and ethanol have different boiling points. You should always make cuts if you want a quality product.

 

Suggest people read Firewater on Reddit - there is an Australian Home Distillers forum.

Edited by Ishmael Fleishman
  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

×